+91 7508712122, 8872011910, 9888331345    sronsrockbolt@gmail.com
srons engineers india manufacturers exporters of rock bolts self drilling anchor bolts systems
  • Home
  • About Us
  • Products
    • ROCK BOLTS
    • SELF DRILLING ANCHOR SYSTEMS
    • FOREPOLING DRILLING SYSTEM
    • DOUBLE CORROSION PROTECTION ANCHORS
    • STEEL DOWEL BARS
    • THREADED RODS / THREAD BARS
    • TIE RODS / COIL RODS / SDA BARS / HOLLOW BARS
    • HOT ROLLED THREADED RODS / TIE RODS
    • PLAIN WASHERS / FLAT WASHERS
    • SPRING WASHERS
    • HEX BOLTS
    • HEX NUTS
    • STEEL FIBER / CONCRETE STEEL FIBER
  • Quality
  • Infrastructure
  • Exports
  • Projects
  • Enquiry
  • Contact

Steel Fiber / Concrete Steel Fiber / hook end steel fiber / Loose steel fiber / Glued steel fiber

Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View Steel Fiber / Concrete Steel Fiiber manufacturers exporters in india punjab ludhiana View

Glued steel fiber refers to loose hooked end fibres glued together in a row way. The big difference between loose and glued fibers is that the former is easy to block together and the latter is easy to disperse uniformly. Due to excellent tensile strength, bending and shearing strength, high tenacity, resistance against the cracking, impact and fatigue, glued steel fibres widely used in building, road, bridge, tunnels, airport runway, water conservancy projects, precast, military projects, blast resistant structures, etc.

Material Low Carbon Drawn Wire
Aspect Ratio 60
Length (mm) 30 mm
Diameter (mm) 0.60 mm
Tensile Strength > 1100 MPa
Appearance Clear, Bright, Loose unglued with hook end anchorage
Conforms to EN 14889-1, ASTM A820 M04 Standards
Suitable Application Tunnel Shotcrete, Slope Stabilization, Precast Pipes

 

Mixing

- Srons Engg. Steel fibers can be added before, during or after the batching of the concrete, as outlined by ASTM C-94 (4-5 minutes at mixing speed or approximately 60-70 revolutions).
In the batch plant fibers can be added by a shaker or through a hopper to the aggregate on a conveyor belt during aggregate addtion and mixed in the normal manner.
- If Fiber are added in the mixer truck the drum shoud be rotating at maximum speed while fibers are slowly added. This is important to avoid clump avoiding balling effect.
- Depending on fiber type and dose rate the concrete slump should be increased by the addition of superplasticiser before fibers are added.
- Use of Micro Sillica is beneficial along with steel fibers.
- Do not use Steel fiber as a first component in the concrete mix.

Placing and Finishing

- Use of Internal and External vibrator (including vibrating screeds) is recommended.
- Finishing of the concrete surface is usually accomplished by using conventional power or hand equipment.
- The use of a surface hardener to achieve a smooth and hardened surface will also help to cover fibers close to the surface.
- Do not use Wood Floats, Wood floats tend to tear the surface and should not be used.

Precaution

To avoid chocking in the pumping operation of the concrete mix, please note that The Hose diameter should be approximately 50% greater than the fiber length. Testing is recommended before execution.

Safety & Handling

- It is recommended that gloves and appropriate eye protection must be used while using fibers.
- Fibers concretes/shotcretes contain Portland cement and thus normal safety precautions used when handing conventional cement based products should be followed.
- Store in dry place.
- Do not use Hooks.
- No Stacking.

Packaging

- Available in 15/20/25 kg Non Woven HDPE Bags & Paper Laminated Bags.
- Palettes available on request


Enquire Now

Links

  • HOME
  • ABOUT US
  • QUALITY
  • INFRASTRUCTURE
  • EXPORTS
  • PROJECTS
  • HTML SITEMAP
  • XML SITEMAP
  • PHOTO GALLERY
  • ENQUIRY FORM
  • CONTACT US

Products Range

  • ROCK BOLTS
  • SELF DRILLING ANCHOR SYSTEMS
  • FOREPOLING DRILLING SYSTEM
  • DOUBLE CORROSION PROTECTION ANCHORS
  • STEEL DOWEL BARS
  • THREADED RODS / THREAD BARS
  • TIE RODS / COIL RODS / SDA BARS / HOLLOW BARS
  • HOT ROLLED THREADED RODS / TIE RODS
  • PLAIN WASHERS / FLAT WASHERS
  • SPRING WASHERS
  • HEX BOLTS
  • HEX NUTS
  • STEEL FIBER / CONCRETE STEEL FIBER

Contact Info.

Address:

SRONS ENGINEERS
#B29-536/35, Singla Colony,
Jaspal Bangar Road, Indl. Area-C,
Dhandari Kalan, Ludhiana
Punjab (INDIA)

Email:

rajinder@sronsrockbolts.com sronsrockbolt@gmail.com

Mobile:

+91 7508712122, 8872011910, 9888331345

Social Links


Catalogue Download
make in india logo
USA Canada UK Australia Newzealand Peru Brazil Chile Mexico Germany Italy Israel China Colombia Dubai Turkey Switzerland Austria Finland Norway Poland Czech Republic South Africa Argentina Tanzania Ghana Saudi arabia Oman Iraq Iran Greece Spain France Sweden Gorgia South Korea Russia Japan Phillipinan Malaysia Indonesia Vietnam Sri Lanka Bangladesh Ireland Denmark Netherland

SRONS ENGINEERS All Rights Reserved. XML-Sitemap HTML-Sitemap

Website Developed & SEO by King IT Solutions